7.62x25 Pistol Barrel Shroud
The barrel shroud needs to be 9 9/16" over all that is from the end of
the muzzle break. A length of tubing is supplied to weld on the back. First
grind off the rear of the shroud so it is square.
the muzzle break. A length of tubing is supplied to weld on the back. First
grind off the rear of the shroud so it is square.
Clamp the tubing extension on and weld it across the top and tack the
lower sides as shown.
lower sides as shown.
When this is done it is time to heat & beat. Heat the extensions till
they are dull red and form them over with a hammer, they will bend easily,
a small hammer will do.
they are dull red and form them over with a hammer, they will bend easily,
a small hammer will do.
