7.62x25 Pistol Barrel Shroud 2
when you are done the bottom should look like this, do not use
excessive force as you will bend the tubing. It may be necessary to trim
the ends a little to get the ends to fit flush. Now weld it up.
excessive force as you will bend the tubing. It may be necessary to trim
the ends a little to get the ends to fit flush. Now weld it up.
After it is welded grind the welds smooth, a sanding drum in a dremel
works good for the bottom. Once it is all ground the shroud is done.
works good for the bottom. Once it is all ground the shroud is done.