Bench Pod build tutorial 3
 | |  | |  | |  |
When you are satisfied with the fit of the front legs mark the bottoms
and cut the back angle so the feet sit flat. When you are done with that
square up the front section to the rear section and weld it all in place.
and cut the back angle so the feet sit flat. When you are done with that
square up the front section to the rear section and weld it all in place.
Cut 2 2" squares and 1 2" x 3" section of 2" x 1/8" steel for the pads,
round the edges and corners and weld in place
round the edges and corners and weld in place
When you are done it should look like this. The base is done, next
step is to apply a finish and glue on the rubber foot pads.
step is to apply a finish and glue on the rubber foot pads.
| | | | | | |
I gave it a coat of Rust-Oleum textured black paint. Cut 2 2" squares
of rubber and one 2" x 3" piece and glue them to the bottom of the feet.
of rubber and one 2" x 3" piece and glue them to the bottom of the feet.