DP-28
I purchased 2 kits, one from Alegheny Arsenal, it had an uncut shroud
and a section of the front of the receiver. I later got another kit from MGS
that had all the receiver sections, but the shroud was cut and the front
section of the receiver was cut really bad. This left me with an overlapping
section in the front with intact barrel threads.
After machining the front section square I cut and machined the center
section to fit. There is a considerable gap in the rear cut, so it will need
some filler sections.
and a section of the front of the receiver. I later got another kit from MGS
that had all the receiver sections, but the shroud was cut and the front
section of the receiver was cut really bad. This left me with an overlapping
section in the front with intact barrel threads.
After machining the front section square I cut and machined the center
section to fit. There is a considerable gap in the rear cut, so it will need
some filler sections.
There is a big gap in the top and sides, I plan on milling the cuts
straight and adding filer sections. I hope to preserve the markings on the
top.
straight and adding filer sections. I hope to preserve the markings on the
top.
 | |  | |  |
| | | | |