 | |  | |  | |  | |  |
Riveting Tutorial 3
By now you should have assembled this thing 2 or 3 times using pop rivets
and have drooled over it so lets get this thing done so you can go shoot it. You
should have trimmed the positioning plate to the same width as your trunnion
and set it in place atop the lock, clamped it in place with a "C" clamp through the
empty feed block area and marked the location of the .125W X .060D slots in the
left and right side plates.
Use the furnished carbide end mill. The denial plate with the trip should be
trimmed to .120 wider than the test or marking plate, clearances are built into the
denial plate. See furnished instructions for more on this. If the top of the cut is
not in the range of about .140 from the top of the side plates you better check it
again and if it's still way off you better call me before you make these cuts cause
some thing's off.
and have drooled over it so lets get this thing done so you can go shoot it. You
should have trimmed the positioning plate to the same width as your trunnion
and set it in place atop the lock, clamped it in place with a "C" clamp through the
empty feed block area and marked the location of the .125W X .060D slots in the
left and right side plates.
Use the furnished carbide end mill. The denial plate with the trip should be
trimmed to .120 wider than the test or marking plate, clearances are built into the
denial plate. See furnished instructions for more on this. If the top of the cut is
not in the range of about .140 from the top of the side plates you better check it
again and if it's still way off you better call me before you make these cuts cause
some thing's off.
