1919A4
Spade Grip Build Tutorial 2
Install one of the long pins and make sure the linkage
and trigger fit loosely with no binding, then trim the excess
off the pin.
and trigger fit loosely with no binding, then trim the excess
off the pin.
Locate and drill a .096" #41 hole in the trigger retaining ears, 1/8" in
from the rear and 5/16" up from the bottom on both sides.
from the rear and 5/16" up from the bottom on both sides.
Now pin in the trigger with a long pin and make sure the assembly fits
freely with no binding.
freely with no binding.
Now assemble the grips with the top and bottom plates with the 1/4"
screws and get the parts aligned and tighten the screws.
screws and get the parts aligned and tighten the screws.