VZ58 Build Tutorial 4
Now install the ejector and stake it in place with a center punch.
The next step will be to fit the fire control group. You will need the
safety and trigger from the kit, the sear bar spring and pin will be used
from it. I opted to modify and use the original pins as there are some
problems with the ones from ORF.
The other parts shown are the semi auto sear and pin, trigger and
sear bar, safety retainer and new pins. Check the safety and pins for fit
and correct as necessary.
safety and trigger from the kit, the sear bar spring and pin will be used
from it. I opted to modify and use the original pins as there are some
problems with the ones from ORF.
The other parts shown are the semi auto sear and pin, trigger and
sear bar, safety retainer and new pins. Check the safety and pins for fit
and correct as necessary.
Now we will prep the sear, the hole in the sear for the roll pin is to
small, the pin measures .093, so I use a .089 drill to open up the hole.
instal the pin as shown in the photo.
small, the pin measures .093, so I use a .089 drill to open up the hole.
instal the pin as shown in the photo.
I decided to modify the original pins as the headless ones that come
with the Kit can shift causing problems with the FCG parts. Since the new
receiver is thicker, the slots for the retaining clips need to be re cut. I did this
in my mini lathe with a mini die grinder and cutoff wheel.
with the Kit can shift causing problems with the FCG parts. Since the new
receiver is thicker, the slots for the retaining clips need to be re cut. I did this
in my mini lathe with a mini die grinder and cutoff wheel.
Next assemble the US trigger and sear bar using the pin and spring
from the one from the kit.
from the one from the kit.
