 | |  | |  | |  | |  |
In order to keep the plate at 80% the 4 radiused corners in this slot will
need to be finished. A few strokes with a file will take care of that. The slots
are the correct width and the parts slide right in, the rear radius for the
roller plate is an exact match.
All said this plate will satisfy the most discriminating builder and will
make the build a lot easier due to the care taken to ensure all the
dimensions are correct.
Michael really deserves a hearty well done from all of us for these
plates!!
need to be finished. A few strokes with a file will take care of that. The slots
are the correct width and the parts slide right in, the rear radius for the
roller plate is an exact match.
All said this plate will satisfy the most discriminating builder and will
make the build a lot easier due to the care taken to ensure all the
dimensions are correct.
Michael really deserves a hearty well done from all of us for these
plates!!
One of the other problems that was corrected was the position of the
rear lug and holes for the back plate, the fit is now dead on. The pins slid
right in like they were spot drilled from the back plate, I was really
impressed with that. As you can see in the lower photo the hole alignment is
dead on.
rear lug and holes for the back plate, the fit is now dead on. The pins slid
right in like they were spot drilled from the back plate, I was really
impressed with that. As you can see in the lower photo the hole alignment is
dead on.
